Features:

* Quick speed lens cutter.

* Cut CR lenses which are below 1.61

* Imported milling cutter

* With a knob to control the size of lens to cut.

* Net weight:  5kg.

* Accessories:  3pcs of sucker（Topcon,Briot and Takubo）,1pc of rubber chuck and 1pc of brush.

* Produce size:  34*31*19cm.

Operation procedure:

* Put lens template to template position,clamping it by the right knob.

* Put a lens which has been marked the axis on lens meter and layout blocker into the position of lens and

  then fix it by the left knob.Waiting for cutting.

* Power on,put down the machine head lightly.Make the lens on the middle position of milling cutter.

* Lift up the machine head after turning a circle.Take off the made lens carefully.

* Then finishing it by hand lens edger is ok.

.

Notice:

* Except lens cutting,please don’t use it in other things.

* Please don’t touch milling cutter when the machine is working,avoid to be hurt.

* When voltage and frequency can’t meet the requirements,please don’t use the machine, you should be

  sure of situation of power supply.

* Don’t put machine in position with high temperature or direct sunlight.

* If any liquid or material is inside the machine,please turn off the machine immediately, and then pull out the   plug.

* It can be used until checked and repaired by professional people.

* Except original components,please don’t install other accessories.

* Please don’t make machine overload,don’t collide any component of the machine.

* Please pull out the plug if you don’t use the machine for a time.